PGT Single-Hung Windows and a Frosted Pool-Bath Door in Port Charlotte

This Port Charlotte job is a classic Southwest Florida retrofit: an existing concrete-block home with textured stucco, where the old windows come out and new white single-hung units go into the same openings. The set also included a door that a lot of pool homes need and few people think about until it is time to replace it — the door from the lanai straight into the pool bath.

Walk through the photos. The first window sits under the soffit in tan stucco and carries a colonial grid, four lites across in each sash. The second is a tall, narrow single-hung on a stucco bump-out, with a simple cross grid. Look closely at that one: there is a band of fresh, lighter stucco around the frame. That is the patch where the wall was cut back to remove the old unit and then returned to the new frame. It is left unpainted on purpose — new stucco needs to cure before it takes paint, so the color match comes later. The third and fourth photos show the same style of window from both sides of a block wall, with a three-over-three grid in each sash.

The fourth photo is the one we like to point at. The PGT label is still on the glass, and it lists a design pressure of +50.0 / -50.0 and a U-factor of 0.29. Design pressure is the wind load, in pounds per square foot, the unit was tested to resist pushing in and pulling out. Your inspector reads that label, so it stays on until the final inspection. Before that, we check the rating against what the opening actually requires — it depends on the wall height, its location on the house, and the design wind speed for that part of Charlotte County.

The door is the other half of the job. From the lanai it is a white single door with one full-height lite, keyed deadbolt and lever. From the bathroom side you can see why it was chosen: the glass is obscure (frosted), so the room gets daylight but nobody on the pool deck can see in. The JELD-WEN and Low-E stickers are still on the glass, and new casing trims the opening inside. Obscure glass in a bathroom door or window is not a cosmetic choice. It lets you skip blinds that mildew in a wet room and still have full privacy.

Single-hung windows make sense in a house like this. Only the bottom sash moves, so there are fewer moving seals than on a double-hung, and the fixed top sash helps the unit hold its rating. Colonial grids keep the look many 1980s and 1990s Port Charlotte homes were built with. On impact units the grids are usually set between the panes or applied to the glass, so they never touch the laminated interlayer that holds the glass together when it is hit.

If you are pricing replacement windows in Port Charlotte, ask any installer these questions. Which Florida Product Approval or Miami-Dade NOA covers this exact product and size? How will you anchor into the block, and what fills the gap between the frame and the opening? Who patches the stucco, and when can it be painted? And for a pool-bath door, does the door meet Florida pool-barrier rules — for example an exit alarm or a self-closing, self-latching device, depending on how the pool is protected?

We are a family-owned, licensed contractor (CRC1327831) based right here in Port Charlotte. If your windows or your pool-bath door are due, call us for a free in-home estimate and we will walk every opening with you.